Search
Member List
Calendar
Help
|
Tail light warning light
|
|
|||
|
So I have converted or replaced all of my lights bulbs to LED. The tail light warning light
is now staying on. I know that is because the resistance is not enough so the Bike thinks I have a burnt out bulb. Is there an easy fix that anybody knows of out there. Or would I require an aftermarket resistor to feed into the wiring some place? Thanks in advance for your replies Bob C |
|||
|
#1
03-21-2011, 05:04 PM,
|
|
|||
|
Mine stayed on for about 300 miles before turning off all by itself. I thought "broken bulb huh?" But it came on again after the battery was disconnected for some work and stayed on for about 80 miles. I have not seen it on again since.
Others have either covered it with some tape, or dived in and removed it.
'RIDE TO BE SEEN' :d
Most common quote from a cager after killing a motorcyclist. "I never saw him" instead of "I never looked for him". |
|||
|
#2
03-21-2011, 05:49 PM,
|
|
|||
|
the wht/yellow wire off the taillight sensor will cut power the the dash lightht
from the schematic it appears that this is a switched ground from the snesor
1987 Aspencade 129K
1986 SEI 93K 2014 Tri-Glide HD 17K Hancock,MD |
|||
|
#3
03-21-2011, 07:00 PM,
|
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)