Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
85 86 GL1200 Petcock seal 16950-MG9-951 $10
Hey all,
So as many of you know, Honda only used this petcock on:
1985 GL1200L A
1985 GL1200L AC
1986 GL1200SEI A
1986 GL1200SEI AC
and it was built to not be disassembled or repaired. Well, I did disassemble it by drilling out the rivets holding it together and found that the seal on the inside had deteriorated badly causing it to leak gas onto my garage floor. Knowing that a rebuild kit wasn't available, I had some seals made and I would like to try and recoup some of my cost by selling the extras I have.
The seal can be replaced without removing the petcock. I removed mine.
Disconnect the battery, drain the fuel, drill off the rivet heads, replace the seal, hold the retaining plate in by drilling out the rivets and using a bolt/nut or, as I did, drill out the rivets, tap the hole and use a 4mm .7 thread x 12mm allen screw.
I won't bs you, the fit is tight, but I CAN turn the petcock to off now.

Anyway, if anyone is interested please PM me and I'll get one to you. dx2olson@msn.com

I'm asking $10.00 each, shipping is included.


Attached Files Thumbnail(s)
   
Reply
#1 02-01-2020, 03:59 PM,


Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html