engine locked up
|
|
|||
Wow, I've never heard of anything shearing the starter clutch bolts before.
Well, all caused as you say by the nut coming loose. That might be because at some point it had been used to turn the engine and someone turned it anticlockwise. It has to be torqued to the correct figure and Loctited as well. For parts the starter chain, oil pump chain, scavenge pump are all the same through the four cylinder Wings. The oil pump chain is not easy to find new though. The pump shaft is a 1200 part. Any good auto sealant will do. Don't use silicon. Yamabond, Hylomar or one of the new anaerobic sealers. I use one from Delta Adhesives but not sure if it's available where you are. ps when fitting the scavenge pump, do this first: http://www.wingovations.com/scavenge-pum...4579471109
'Impossible' is just a degree of difficulty!
![]() |
|||
#2
09-28-2014, 07:08 PM,
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
engine locked up - by tackleberrywkb - 09-22-2014, 04:18 PM
RE: engine locked up - by Old Fogey - 09-28-2014, 07:08 PM
|
Users browsing this thread: 1 Guest(s)