GL1200 GOLDWINGS › TECH CENTER › LIGHTING AND ELECTRICAL v
Fans not working

Thread Rating:
  • 3 Vote(s) - 3.33 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Fans not working
BearOnt Offline
Member
***
 		Posts: 106
Joined: Apr 2007 Location: Bike: 
Where is the fuse for it?
Reply
#1 07-22-2007, 04:24 PM,
myplace 46 Offline
Senior Member
****
 		Posts: 565
Joined: May 2007 Location: Bike: 
Hmmm...
That's a good question Bear, I checked two manuals and neither one says anything about the fuse! my guess is it has to be in the main fuse block under the tank shelter. Just check each fuse with a test light till you find it.
John
John McFarland
Chapter Director
GWRRA FL2-W
member 367388
Reply
#2 07-22-2007, 04:41 PM,
SIR tricky Offline
WISE AND HELPFUL MODERATOR
******
 		Posts: 4,305
Joined: Dec 2006 Location: Waterford, Ontario Bike: 1985 Aspencade, Satellite Blue
The schematic shows #1 fuse controls the fan circuit. If that isnt the problem, it is more likely to be a broken wire down by the fan, it gets hot down there and it's hard on the wires.
Also it could be the fan switch.
The only stupid questions are the one's that are not asked.
Reply
#3 07-22-2007, 04:47 PM,
Guest
Guest
 		 
I once had a problem with my fan not kicking on and found it was the electrical connector on the left side down by the triple tree. It was fine it had just lost contact. I cleaned it up and unplug and pluged it together a dozen times then used dielectric grease and it started working just fine. The little tabs that hold the connector together had broken off so it just wiggle loose.

Give it a check! Of course you have to pull the shelter off to get in there.
Reply
#4 07-22-2007, 05:06 PM,


Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html