Thread Rating:
  • 2 Vote(s) - 2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Anyone close with a carb tuneing tool?
as it is i can not afford to buy a carbtune and cant afford to have local shop sync my carbs is anyone near sw missouri that can help with a sync? thanx
[Image: VisitedStatesMap.jpg]
#1 10-03-2011, 04:56 PM,
Someone should help you out. I'm way down here in Fl. Good luck.
#2 10-05-2011, 05:46 PM,
Thanx for the reply I am hoping someone will be Able to help
[Image: VisitedStatesMap.jpg]
#3 10-05-2011, 06:28 PM,
I'm in Batesville, Arkansas if that is close enough. Don't think I could steer clear to come to you for two or three weeks, though.
#4 10-06-2011, 06:01 AM,
hey thanx for the reply if you head anywhere up this way let me know ill meet up with ya ill try to get enough cash together to make a round trip down that way in case you cant swing up this way. thanx again robert
[Image: VisitedStatesMap.jpg]
#5 10-06-2011, 06:10 AM,
I am also a member of the Steve Saunders forum.

one of the things that a few members have done is to create a pool of 'loner tools' that are shipped around to whoever needs them, just so long as they are then shipped to the next member who needs it. I believe that the carb sync tool is one of them too.

Another member found one on Ebay (from China) that was cheap enough, and it actually arrived with the mercury too. Of course it took a while to get here!

You don't need a four carb tool either since you are only doing one at a time a two carb tool will work, however a four carb tool is nice to have if you can.
Or you can build your own from some tubes of clear hose, attached to a board, fill with colored water/oil, and fit the 5mm nozzles to the ends, alternatively you can drill out some of the correct sized bolts and push the hoses over them. Just do a Google search for DIY carb sync. and you will find plenty of links to some good sites with pictures, descriptions, and even videos on doing this.

Most common quote from a cager after killing a motorcyclist.

"I never saw him" instead of "I never looked for him".
#6 10-06-2011, 06:25 AM,
thank you
[Image: VisitedStatesMap.jpg]
#7 10-06-2011, 06:44 AM,

Forum Jump:

Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html