GL1200 jet needles
|
|
|||
Hi Folks,
I am having a rich running problem on my 86 GL1200 Aspencade. I pulled the jet needles out of the carbs and found them to have a flat spot along the taper of the needles. I am assuming that these jet needles should be perfectly round along the entire length of the shaft. I have also looked at a friends needles and his are also showing a flat spot. 1. Should these needles be round along teh entire length of the shaft? 2. Anybody know where to get a replacement set of jet needles and jet needle holders? I cannot find a source for replacements anywhere. Thanks, Stephen. |
|||
#1
07-04-2011, 11:33 AM,
|
|
|||
You might talk to this person:
<!-- m --><a class="postlink" href="http://www.randakks.com/Carb%20Parts.htm#9B">http://www.randakks.com/Carb%20Parts.htm#9B</a><!-- m -->
The only stupid questions are the one's that are not asked.
|
|||
#2
07-04-2011, 12:44 PM,
|
|
|||
Yes, I have checked Randakk's website, I will be ordering a carb overhaul kit from him, but it does not include the jet needles.....
|
|||
#3
07-04-2011, 04:41 PM,
|
|
|||
I got a set at my local Dealer, you might try checking out some of them.
Ride safe have fun and enjoy. Lane
1985 Aspencade 2002 Vulcan |
|||
#4
07-04-2011, 06:03 PM,
|
|
|||
Hi Bluewing, Who is your local dealer, mine does not have any. I can try calling your dealer
|
|||
#5
07-05-2011, 08:13 AM,
|
|
|||
Tradersden Wrote:Hi Bluewing, Who is your local dealer, mine does not have any. I can try calling your dealer I got mine a Cameron Cycle in Peterborough Ontario. I just phoned them and they are out of stock and can't get any more. I will try a few more Dealers in this area tomorrow and let you know if I find any.
Ride safe have fun and enjoy. Lane
1985 Aspencade 2002 Vulcan |
|||
#6
07-05-2011, 03:01 PM,
|
|
|||
You could try calling these guys:
<!-- m --><a class="postlink" href="http://jetsrus.com/">http://jetsrus.com/</a><!-- m --> You will need to know the Brand and Model info from your carbs. |
|||
#7
07-06-2011, 05:38 AM,
|
|
|||
Try these people <!-- w --><a class="postlink" href="http://www.siriusconinc.com">www.siriusconinc.com</a><!-- w --> they have a store in Kitchener, Ontario, Canada and somewhere in New York, USA and have the jet needles as part of a overhaul kit. I and a few friends have purchased them and installed them with no problems.
Bob |
|||
#8
07-06-2011, 06:59 PM,
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)