Thread Rating:
  • 5 Vote(s) - 3.2 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Where do resistors get wired in for LED's????
I have an 84 Aspy; and I need to know which wires to put the resistors in so I can run my LED turn signals.

I assume the resistors are not necessary for the Brake/position lights, eh?

TX!
Reply
#1 06-06-2009, 05:35 PM,
No you don't need the resistors for the brake or tail lights. If I remember correctly the resister goes on the hot wire to each turn signal. I can't recall the color of the wires. You will find these wires under the seat where they split to the saddle bags. Good Luck
1986 Aspencade
Reply
#2 06-06-2009, 06:29 PM,
one wire of the resistor taps into the supply wire to the turn signal, the other wire of the resistor goes to ground.
Reply
#3 06-16-2009, 01:49 PM,


Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html