Goldwing LED Kits picture now on our new site
|
|
|||
LED lights is no longer in business
|
|||
#1
01-04-2008, 10:27 PM,
|
|
|||
Your site looks awesome Jim. Is there any satisfaction garantee on your product meaning if I order the Gold Wing kit, install it on my bike and just don't like what I see can I return it for a full refund?
Ed (Vic) Belanger - 1954-2015
Founder of gl1200goldwings.com |
|||
#2
01-19-2008, 01:49 PM,
|
|
|||
Yes, That is part of the deal.
If you are not satisfied, Im not satisfied. The only condition on the full refund is: If the lights were visibly damaged by an improper install, IE: installing an 1157 in a 1156 socket. If modifications were made to the light. Or if improper voltage was supplied to the lights. All of the above are clearly visible. |
|||
#3
01-19-2008, 06:06 PM,
|
|
|||
That sounds fair enough.
Ed (Vic) Belanger - 1954-2015
Founder of gl1200goldwings.com |
|||
#4
01-20-2008, 04:09 PM,
|
|
|||
I just tried this site. It is not totally down. Does anyone know when it will be back? What does the 1200 kit consist of? How much is it? Thanks
Cr |
|||
#5
06-25-2008, 03:13 PM,
|
|
|||
I sent Jim an email and he responded very quickly....
I believe he's still sending stuff out he's just swamped at his full timer..... |
|||
#6
06-25-2008, 03:58 PM,
|
|
|||
Sorry Cloudrider.
The regular job has been keeping me so busy lately I barely have time to sleep at all. But the rush is finally over :!: The kit consists of: all 4 Tail Brake lights all 4 turn signal bulbs 2 headlight marker bulbs and 4 resistors for the turn signals |
|||
#7
06-25-2008, 07:50 PM,
|
|
|||
How do I go about getting a set of the LED lights. And cost? Thanks Brian :?:
1986 Aspencade
|
|||
#8
07-28-2008, 04:39 PM,
|
|
|||
You can send the funds to my paypal.
my paypal address is the same as my primary email. <!-- e --><a href="mailto:pendley200@newwavecomm.met">pendley200@newwavecomm.met</a><!-- e --> the cost for this kit is $134.00 + 5.00 for U.S. shipping or 12.00 for shipping to canada Thanks Jim |
|||
#9
07-28-2008, 04:43 PM,
|
|
|||
any kits for a 1500se?
'75cb750 ,'79cb750superK,
'93gl1500se, '79cb 750f, '85cb450sc, '05sunL70 '06 ST 1300....william |
|||
#10
09-19-2008, 07:07 AM,
|
|
|||
Hi Jim; I got the LEDs a couple weeks ago, installed works and looks great. Is there a way to make turn signals brighter? By the way, I did not have to do the wire modification, just plug and play. Thanks again Brian.
1986 Aspencade
|
|||
#11
09-29-2008, 04:44 PM,
|
|
|||
The turn signals are not bright enough?
Are the inside of the lenses clean? Are all of the LEDs on each bulb lit? we have never had any problems with brightness before, so please check the above items and let me know Jim |
|||
#12
09-29-2008, 06:12 PM,
|
|
|||
When I get the $$ from eBay http://shop.ebay.com/merchant/cherry-val...oZQQ_sopZ1 ( some old boat motor and a hitch off my bike) PayPal will be fat again and now that some of my riding is @ 5AM the brighter LEDs will be a much needed help. This site is great !!
87 Interstate
1954 Ford f100 (my dads and granddads truck) Rust is good Enjoy the ride http://www.calorchard.net/ |
|||
#13
09-29-2008, 09:03 PM,
|
|
|||
L.E.D. Tech,
Could you explain the advantage of switching my lights to LED? I'm aware they are brighter and use much less energy but is that not inconsequential on the 1200's? As I understand it the charging system charges at the same rate no matter the load. The extra output is just sent to ground. The LED's may allow me to draw add a few do-hickeys but won't save the bike from charging at full capacity or am I mistaken?
Lawrence
'97 GL1500SE '98 Valkyrie Std |
|||
#14
11-01-2008, 02:26 PM,
|
|
|||
wpgfire Wrote:L.E.D. Tech, I am not sure how the charging system works, all I know is you will save around 20 amps with all of your lights on including the brake lights. All I can tell you for sure is that my volt meter runs around 14 v now instead of 11.9 to 12.4 I am sure some one else can answer your questions better about the charging system. Jim |
|||
#15
11-03-2008, 10:11 PM,
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 1 Guest(s)