Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Oil Seal
I am looking for an oil seal (25X54X12) for the rear cover which has been discontinued by Honda. The part number is 91201-ML8-003. Is there an aftermarket replacement for it?

Thanks Andy
Reply
#1 06-28-2018, 02:51 PM,
https://www.vxb.com/Oil-and-Grease-Seal-...x45x12.htm
Ken.
Reply
#2 06-28-2018, 05:17 PM,
Thanks Ken!
Reply
#3 06-28-2018, 09:42 PM,
It is the wrong seal
Reply
#4 07-12-2018, 10:31 PM,
Aftermarket seal manufacturers do make a 25x54x8. It isn't as deep, but inside and outside diameters are the same. Since the original is no longer available, this is your next best choice. I haven't seen many of these leak. Are you sure this is what you're looking for?
Reply
#5 07-13-2018, 08:33 AM,
I had the engine out to replace the stator (no I will not install a poor boy kit). I wanted to replace to that seal and what ever else I could while I had access to it.
Reply
#6 08-20-2018, 05:42 PM,
What state was the main fuse when you checked it?

No doubt you will replace the stator again
The only stupid questions are the one's that are not asked.

Reply
#7 08-21-2018, 05:57 AM,
There is nothing wrong with the main fuse. The bike is 32 years old with almost 45,000 miles on it. This is the first time the stator was replaced.
Reply
#8 09-01-2018, 11:06 PM,


Forum Jump:


Users browsing this thread: 5 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html