Thread Rating:
  • 2 Vote(s) - 2.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Engine bars/Headers refittment technique?
It's almost like a puzzle to get those things in place. Just take some time to twist/rotate them around and they should go in place, at the worst you'll just need to loosen the exhaust manifold a bit for extra clearance. Also, drive the stud through the engine so that it does not interfere with the puzzle solving process, then drive the stud back through to the other side when you install the opposite side. Trying to install them with the stud sticking out is an almost impossible feat. Don't worry, the engine will not fall down when you slide the stud over.
Ed (Vic) Belanger - 1954-2015
Founder of gl1200goldwings.com

Reply
#4 03-28-2012, 04:05 AM,


Messages In This Thread
Re: Engine bars/Headers refittment technique? - by admin - 03-28-2012, 04:05 AM

Possibly Related Threads…
Thread Author Replies Views Last Post
  Rusted to crap headers and exhaust pipe Roscowgo 1 214 07-21-2018, 08:31 AM
Last Post: Geofd
  Rebuilding stock 86 Interstate headers Peter 8 1,149 05-31-2011, 02:10 PM
Last Post: Peter
  how to remove old exaust gasket at the headers end 5 673 04-12-2011, 07:19 AM
Last Post: unionjack
  leaky headers goldwingblue44 2 438 11-12-2008, 10:25 PM
Last Post: roscoepc

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html