GL1200 GOLDWINGS › TECH CENTER › EXHAUST v
Cross over chamber

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cross over chamber
85GL1200I Offline
Super Moderator
******
 		Posts: 1,266
Joined: Dec 2006 Location: Johnstown, Pennsylvania Bike: 1985 Gl1200I Blue
I never heard anything good or bad about eliminating the crossover.

I think I would be tempted to find somebody that welds to close those holes up if they are not too bad. I would think it could be done on the bike, if you can lean it far enough to gain access.

From what they say taking that exhaust off is a real bear of a job.
A rainy day off beats a sunny day at work any time..................
Reply
#6 03-13-2012, 04:40 PM,


Messages In This Thread
Cross over chamber - by ghostrider52005 - 03-12-2012, 10:59 PM
Re: Cross over chamber - by Roleketu - 03-13-2012, 01:36 AM
Re: Cross over chamber - by Burnout - 03-13-2012, 02:33 AM
Re: Cross over chamber - by PanMan75 - 03-13-2012, 03:13 AM
Re: Cross over chamber - by ghostrider52005 - 03-13-2012, 03:24 PM
Re: Cross over chamber - by 85GL1200I - 03-13-2012, 04:40 PM
Re: Cross over chamber - by ghostrider52005 - 03-13-2012, 07:27 PM
Re: Cross over chamber - by spongebob - 03-13-2012, 11:43 PM
Re: Cross over chamber - by ghostrider52005 - 03-21-2012, 12:14 AM
Re: Cross over chamber - by ghostrider52005 - 04-27-2012, 12:09 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html