Thread Rating:
  • 6 Vote(s) - 3.17 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gl1200I and A 84-87 Main wire harness
All,

First thanks for any help or info given. I have a 1985 GL1200I I purchased as a project bike. I won it in a salvage auction "burn" , and after taking the ABS/fairing off, the actual burn is the main wiring harness. From inspection, the harness looks like it was rubbed open against the frame, rub a hot open, and grounded into Clutch Safety wire (Green/red stripe). NO fuses where blown, neither 7.5 nor 20 under the left pocket or any in the fuse panel. Even the Starter solenoid fuse was in tact, but the wiring harness connector going into the starter solenoid was melted . So get a new to me solenoid as well.

The question is I found several Main Harness take offs, vendors claim they fit 84-87 but I can't get a part No# verification from Honda Distro Micro Fiche's, since they are no longer available to verify. So are all the 84-87 GL1200I and A harness's the same ? I ask cause I found x2 different connectors for the GL1200 CDI, which I'm hoping I don't have to replace ..

Thanks again .
Reply
#1 10-13-2011, 12:23 PM,


Messages In This Thread
Gl1200I and A 84-87 Main wire harness - by bassplayer88 - 10-13-2011, 12:23 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html