Thread Rating:
  • 4 Vote(s) - 2.5 Average
  • 1
  • 2
  • 3
  • 4
  • 5
One more thing to check when syncing carbs....
Hooked the gage up and noticed the left carbs were in sync with each other and the rights were in sync with each other but both sides were way off from each other. Hmmmm, kinda strange but what the heck I'll adjust them. Thats where the fun began. I just couldn't get them to all have the same reading. I finally found that the right side linkage was a bit gummy from road grime or????. A shot of WD-40 freed it up and I was able to sync all 4 carbs to the same reading.Big Grin I've never run into this problem nor have I read about it so thought I would post it as "food for thought" to you folks.
“A good traveler has no fixed plans,and is not intent on arriving”~ Lao Tzu ~
[Image: 16hvxut.jpg]
[Image: 15r1pnl.jpg]
In Stable
1985 GL1200 Interstate(RIP)
2003 Yamaha Midnight Venture
2008 Yamaha V-Star 650(Wife's Bike)
Reply
#1 03-29-2009, 04:14 PM,


Messages In This Thread
One more thing to check when syncing carbs.... - by MikeM - 03-29-2009, 04:14 PM

Possibly Related Threads…
Thread Author Replies Views Last Post
  5mm fittings for carb syncing neoracer 2 482 12-07-2009, 05:07 PM
Last Post: admin
  Carb syncing lostinflorida 19 2,422 02-22-2009, 08:25 AM
Last Post: bluewing

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html