Thread Rating:
  • 3 Vote(s) - 3.33 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Just clean the durn thing!
In addition to the above work you should also add a ground wire between the brush plate and a small nut and bolt added through the end cone of the motor casing. This provides a clean and secure ground even when the inside do get dirty. Most starters begin to fail/turn slowly when hot because the plates ground is created simply by it's touching the dirty case of the motor, but the casing expands when hot, and this makes a very poor contact between the two.
'RIDE TO BE SEEN' :d

Most common quote from a cager after killing a motorcyclist.

"I never saw him" instead of "I never looked for him".
Reply
#13 07-12-2012, 07:29 AM,


Messages In This Thread
Just clean the durn thing! - by Winger Ed - 11-12-2007, 11:50 PM
[No subject] - by admin - 11-13-2007, 11:11 AM
[No subject] - by Danooo52 - 01-30-2008, 01:44 PM
[No subject] - by admin - 01-30-2008, 05:03 PM
[No subject] - by Guest - 01-31-2008, 06:21 PM
Re: Just clean the durn thing! - by MikeM - 05-27-2008, 06:15 PM
Re: Just clean the durn thing! - by 84cade - 12-11-2008, 11:58 AM
Re: Just clean the durn thing! - by bs175dths - 07-05-2012, 08:59 AM
Re: Just clean the durn thing! - by spongebob - 07-05-2012, 12:45 PM
Re: Just clean the durn thing! - by firstwing85 - 07-11-2012, 12:19 AM
Re: Just clean the durn thing! - by bs175dths - 07-11-2012, 02:54 PM
Re: Just clean the durn thing! - by unionjack - 07-12-2012, 07:29 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html