Re-assembly questions
|
|
|||
Correction to my previous post. The interference area was next to carb 3 not carb 4.
Big thanks to bs175dths...your suggestion to use the "proper" size line was right on target. The stock fuel hose is 5.3 mm, which is about 3.2/16 of an inch. Went down to the local Bumper-to-Bumper today and picked up 2 ft of 3/16" fuel line to use from the T-fitting to the carbs. The 3/16 is much more flexible than the 1/4. Since I went down a size, I could use the Honda wire clamps. Still have a little interference problem but not nearly as pronounced as with the 1/4 line. To protect it, I used some of the hose guard that was on the bike before the cleaning started. I needed to split it length-wise so I could wrap it around the installed hose (see attached). Thanks for the suggestion! - Pete |
|||
#6
06-26-2014, 07:20 PM,
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Re-assembly questions - by pstelter - 06-22-2014, 12:43 PM
RE: Re-assembly questions - by pstelter - 06-22-2014, 06:49 PM
RE: Re-assembly questions - by Roleketu - 06-23-2014, 03:30 PM
RE: Re-assembly questions - by pstelter - 06-23-2014, 08:23 PM
RE: Re-assembly questions - by bs175dths - 06-24-2014, 02:27 PM
RE: Re-assembly questions - by pstelter - 06-26-2014, 07:20 PM
|
Users browsing this thread: 1 Guest(s)