Re-assembly questions

[pstelter]

Thanks again to BigBro for the slide diaphragm re-test procedure. Turns out I needed a couple of extra tries on carb #2.

Having come through that, I have begun re-assembling the carbs, but they don't want to go together. I can get them in place with no o-rings installed, but that won't work. When I install the o-rings where I think they should go, the pipes don't want to seat and the carbs just fall apart.

1. The Randakk kit comes with four small o-rings per carb but doesn't tell you where they should go. Two appear to be identical, one is the same diameter but thicker, and one is really small. Attached is a picture that shows how I have them assigned them. Is this correct? What are the small o-rings for?

2. The second picture shows the throttle linkage for carb #2 as it engages with the linkage for carb #4. However, it looks like it will interfere with the arm spring that is installed between the yoke arms on #4. Is this the correct set-up?

Thanks.

- Pete