Thread Rating:
  • 4 Vote(s) - 2.75 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Driving light mounts for 86 SEi model
This is an ASPY schematic I presume the SE is similar. I would tend to do something like this. The relay could be tucked in behind the headlamp, run a fused line from the battery to the relay, when the low beam is activated so is the relay.

[Image: auxrelay.jpg]
The only stupid questions are the one's that are not asked.

Reply
#16 02-18-2008, 07:23 AM,
Yes, the white wire comes out of the switch to the headlight. Where you tie in is a matter of preference. Remember, you're going to have to mount a relay somewhere, so keep that in mind when your running your wires. It is very tempting to use "scotch locks" but try to resist. The only good connection is a soldered one. You're also going to need a fuse to protect the circuit. Put the fuse as close to the battery as possible in the event of a crimped or chaffed wire. A "lighted" control switch would also be a good idea, so you know when the lights are on.

.[Image: 87946gudrelay.jpg]
Reply
#17 02-18-2008, 01:09 PM,


Possibly Related Threads…
Thread Author Replies Views Last Post
  license plate light, neutral light, front brake light problems steelhorseangel 8 2,819 07-16-2013, 03:35 PM
Last Post: bs175dths
  Picture of Aux Lighting Mounts BigBro 10 2,371 05-08-2013, 03:56 AM
Last Post: Roleketu
  driving light question 5 1,165 05-23-2008, 10:25 PM
Last Post: Guest
  Aux. driving light conversion LTD/SEI TNroadrider 24 3,843 11-01-2007, 06:10 PM
Last Post: SIR tricky

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | GL1200 GOLDWINGS | Return to Top | | Lite (Archive) Mode | RSS Syndication
google-site-verification: googled4b4fe31e07b65d8.html