STARTER HARD TO TURN BY HAND: normal or not? - Printable Version +- GL1200 GOLDWINGS (http://www.gl1200goldwings.com/gl1200) +-- Forum: TECH CENTER (http://www.gl1200goldwings.com/gl1200/forumdisplay.php?fid=39) +--- Forum: STARTER (http://www.gl1200goldwings.com/gl1200/forumdisplay.php?fid=6) +--- Thread: STARTER HARD TO TURN BY HAND: normal or not? (/showthread.php?tid=8177) |
STARTER HARD TO TURN BY HAND: normal or not? - Guest - 04-21-2011 i took off my starter because last summer ometime start slowly when hot. so order a kit before i remove starter. just in case i change bearing , seal,sleeve, the brush was only 2 mm used , i kept it..... and clean armature. when i did close all covers......now it is very hard to turn pinion by hand or 2 finger. on floor the starter dont dance when i connect to car battery. reinstall starter on bike , with security switch at off , push button and engine crank as normal. my bike is in my home can not try hot for now. so do i reinstall muffler and all stuff ? dont know if it will be ok when hot starting this summer. like i said , hard to turn by fingers........... normal or not thanks Re: STARTER HARD TO TURN BY HAND: normal or not? - Ranch55 - 04-22-2011 It is hard to turn by hand beacuse of the gear reducer (gearbox). I just rebuilt my starter yesterday also. I found nothing wrong with it, but I am doing a "Rick's Stator" replacement job right now also. My starter is very hard to turn by hand, but runs good on a battery on the work bench. Normal.................... Re: STARTER HARD TO TURN BY HAND: normal or not? - bluewing - 04-22-2011 When I checked my starter out it was hard to turn as well, I think it is normal. |